GRID+ v2 Improvments
I just recently bought a GRID+ 2 for my system and attached six EK-Vardar F4-120 2200 RPM fans to it, but I got some issues, not specifically with those fans, but with the CAM Software in general.
1. It does not autostart in Windows 10, even if I manually add it to a task. It seems like the CAM Launcher is broken for some reason. Uninstall, reinstall, clean all installed files etc. did not help.
2. The fan control is ok, but I'd prefer if you could add 5% values instead of those 10% because my fans are making a huge difference in noise between 55 and 60% speed.
3. I'd wish that there would be a default "low noise" setting for the CAM hardware that you can set withing CAM, for the case when the PC is booting or not using the CAM Software, for example if one has a Linux system running.
Frank Thompson commented
I know this has been added before, but that was in 2015 for the Grid+. I have the Grid+ v2. I would like to be able to adjust my fans based on motherboard temp as well. It seems silly that a fan controller is limited to cpu/gpu temps. For instance I don't have a GPU, so I am stuck with CPU to control all 5 of my fans (I have 2 more for the CPU, but the MB actually takes care of those)
Disable the CAM in the task scheduler and create a new CAM rule
Start CAM, start at logon rule, CAM_V3.exe run with higher privileges, uncheck boot only on powerline
FYI, you are controlling PWM-fans with a DC controller. You will never have good control over your vardar pwm-fans with that controller.